- This topic has 2 replies, 1 voice, and was last updated 2 years, 2 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
If the quarter panels are slightly hanging over the edge of the galley flat (tried multiple times to “force” it on top but the angle just is off slightly to allow it) do you cut/plane off the bottom of the quarter panel to get it to sit on the GF? Then fillet in any slight gaps in the corners?
Thanks for any input.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.