Started working on one of these. Running into an issue with getting panel assembly #1 flush. We tightened it in the other day and when I came back to it today one of the panels was cockeyed a bit, about a 1/16” difference. With it sitting like that for a little bit I can’t adjust it now even after unfastening the stitches to the mold.
While we were originally fastening the mold it also seemed like the pre cut holes were just off everywhere, we fastened at mold 1, then did mold 4. At that point the instructions don’t say which to next so we just went numerically from 2-7.
Anyone else have a similar issue? Any tips or hints?