badger317

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 7, 2022 at 7:36 am in reply to: Gas struts on galley hatch #4386
    badger317
    Participant

    Thank you @RowingBoatmanSteve.  PS I like the map on the underside of your galley hatch.  Nice touch.

    July 3, 2022 at 11:34 am in reply to: Gas struts on galley hatch #4367
    badger317
    Participant

    @RowingBoatmanSteve where did you fid the brass telescoping stays. Those are slick.  I was just looking to replace the supplied gas springs when I saw your post.  Thanks.

    July 13, 2020 at 8:41 am in reply to: Door and Window cut-outs #3128
    badger317
    Participant

    Thanks and glad I found this.  I’m at the same stage and noticed the saw kerf was narrower than the CNC dotted lines.  Good tip to check the windows in the cutouts as I needed to sand down to remove the CNC dotted lines before they would fit.  I will file and sand until things look good.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)