[MIKEinMT]

THANKS! – my main issue was trying to figure out how to house the breaker…you’ve given me some good ideas.  My setup is a little different since I’ll be putting the breaker up front in the trailer tongue box.

[MIKEinMT]

Ok – I just talked to CLC…Depends on how you apply paint / varnish…but an estimate using rolling-tipping technique –

1.  Bottom  Precoat (1 coat)                               – 1 quart ….I’m ordering 2 to be sure

2.  Bottom Brightsides (2 heavy coats)           – 1 quart…I’m ordering 2 to be sure

3.  Exterior (3 + coats)                                        – 3 quarts….I’m ordering 4 to be sure

mj

 

[MIKEinMT]

Yes – I checked stiffeners…they still fit.  I’m just a little worried about tolerances for hatch hardware (where the hatch hardware pivot fits).  I couldn’t find anything in manual about exact location, though it looks right.  After thinking about it more…I guess I probably should dry-fit door hardware before I glue things together.

 

thanks for reply

 

[MIKEinMT]

thanks…that was my intuition…but glad to hear you didn’t have any issues when cutting the doors.

[Author]

Posts