Door striker plates

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2364
    Diving Duck
    Participant

    Starboard Striker Plates  I got tired of the door latches rubbing on wood, so I used some thin aluminum bar stock to fashion striker plates for each door.  The plates are about 4” x 1”.  They need to be mounted high enough to allow for the full swing of the door latch.  The project took about 30 minutes.

    • This topic was modified 5 years, 11 months ago by Diving Duck.
    #2378
    ArtisticAdam
    Participant

    I too did the same modification with a couple of 3″ stainless steel mending plates.  Honestly the CLC hardware kit should include a couple of strike plates.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.