Forum Replies Created
-
AuthorPosts
-
smithn00
Participanteverything gets coated with epoxy. I would do it as installed.
smithn00
ParticipantI know most small trailers have this stated warning. And I would not publicly say the warning is unwarrented. But I have not had a problem. with highway speeds. Keep the tires well inflated and the hub greased.
smithn00
ParticipantTwo years ago I used a Northern Tools trailer . It has worked well on a few trips from Chattanooga to Florida.
https://www.northerntool.com/shop/tools/product_200660344_200660344
smithn00
ParticipantExactly, I don’t remember. That was over a year ago. About 6″ I think.
smithn00
ParticipantI have a Northern Tools trailer. I moved the axle back several inches and relocated the fender on its support bracket to solve this problem.
smithn00
ParticipantAt lease 3.
smithn00
ParticipantI used a suction floor lifter to place the camera at the very bottom edge of the galley lid. I bought the monitor type that sits on the dash board. I think now I should have bought the type that clips to the existing rear view mirror.
smithn00
ParticipantI asked NT what the speed rating of the High Speed Hub was. They replied that hubs were not rated, only tires were rated for speed. I asked back “Then why are they called High Speed Hubs.” They have not replied to that yet.
smithn00
ParticipantFor overhead lights, as close to the ceiling in the center of the bulkhead as I could get.
smithn00
ParticipantI sanded the shelf. It gets it’s own filets.
smithn00
ParticipantI put mine on the bottom. the wires can be led through the hole and retained with the finishing ring/square.
October 22, 2018 at 9:23 am in reply to: New to forum, are there any teardrops in North Georgia,… #2227smithn00
ParticipantYes. I am retired so almost any time is good.
October 19, 2018 at 4:12 pm in reply to: New to forum, are there any teardrops in North Georgia,… #2220smithn00
ParticipantI’m Ned Smith located near Trenton, GA. I am about two weeks away from being done.
smithn00
ParticipantI moved the shell all the way back on the trailer. I then relocated the axle back 8″ so the fenders won’t interfere with the doors. I will carry the lead/acid battery inside under the galley. The mattress doesn’t reach all the way to the transom.
smithn00
ParticipantCould you explain how you put vinyl on the insulation? Do you mean the grey/black foam that is offered by CLC?
-
AuthorPosts