Forum Replies Created
-
AuthorPosts
-
January 22, 2022 at 11:15 pm in reply to: Glassing inside doors and hatch, is there enough fiberglass? #4131matukasParticipant
Brian,
I was planning to use bed liner on the bottom also.
I understand your point about the bottom changing the geometry of the side near the door. I will look at this when I get there and maybe install the bottom before fiberglassing the inside of the door.
I will report back what I end up doing and how it turns out.
Matthew
January 12, 2022 at 1:48 am in reply to: Glassing inside doors and hatch, is there enough fiberglass? #4117matukasParticipantThank all of you for the good advice.
I bought 12 yards of 4 oz, (CLC only had odds and ends of 6 oz), to do the inside walls where the doors are and to do the inside of the hatch all with 2 coats. I will add the door stiffeners and make one for the hatch, before cutting them out.
I also plan to attach the hinges before cutting out the doors and hatch.
I think I will mark up the manual for these changes so I don’t miss doing them at the right time.
January 11, 2022 at 2:26 am in reply to: Glassing inside doors and hatch, is there enough fiberglass? #4107matukasParticipantJB, How did your doors and hatch fit? Do you think fiberglassing them early helped?
matukasParticipantYou are doing such a nice job with this that I am inspired to try it. I extended the standard model by 20 inches and did a paper model. I am not as good as you are with the model so I will cut wood at small scale and try it. Then I will know if the shapes fit for the full scale model.
matukasParticipantAny update on the progress, we would love to see photos of the interior and how the hatch opens. This is a great modification. It would be nice if CLC would consider offering a 10 foot version in a kit. I may just have to build from plan to try this.
-
AuthorPosts