Forum Replies Created

Viewing 15 posts - 1 through 15 (of 16 total)
  • Author
    Posts
  • in reply to: Backup camera #2515

    smithn00
    Participant

    I used a suction floor lifter to place the camera at the very bottom edge of the galley lid.  I bought the monitor type that sits on the dash board.  I think now I should have bought the type that clips to the existing rear view mirror.

    in reply to: High Speed Tires #2447

    smithn00
    Participant

    I asked NT what the speed rating of the High Speed Hub was.  They replied that hubs were not rated, only tires were rated for speed.  I asked back “Then why are they called High Speed Hubs.”  They have not replied to that yet.

    in reply to: Wire passage from cabin to galley #2445

    smithn00
    Participant

    For overhead lights, as close to the ceiling in the center of the bulkhead  as I could get.

    in reply to: Help with interior shelf #2346

    smithn00
    Participant

    I sanded the shelf.  It gets it’s own filets.

    in reply to: Hatch question #2286

    smithn00
    Participant

    I put mine on the bottom.  the wires can be led through the hole and retained with the finishing ring/square.

    in reply to: New to forum, are there any teardrops in North Georgia,… #2227

    smithn00
    Participant

    Yes.  I am retired so almost any time is good.

    in reply to: New to forum, are there any teardrops in North Georgia,… #2220

    smithn00
    Participant

    I’m Ned Smith located near Trenton, GA.  I am about two weeks away from being done.

    in reply to: Northern Tools Trailer #2215

    smithn00
    Participant

    I moved the shell all the way back on the trailer.  I then relocated the axle back 8″ so the fenders won’t interfere with the doors.  I will carry the lead/acid battery inside under the galley.  The mattress doesn’t reach all the way to the transom.

    in reply to: Internal locking, gas strut locking, battery box #2197

    smithn00
    Participant

    Could you explain how you put vinyl on the insulation?  Do you mean the grey/black foam that is offered by CLC?

    in reply to: Northern Tools Trailer #2195

    smithn00
    Participant

    Make that “Bearing Buddy”.

    in reply to: Moving Battery to the Storage Box #2190

    smithn00
    Participant

    mpilone,

    Under the galley.  That is worth looking into.

    in reply to: Northern Tools Trailer #2185

    smithn00
    Participant

    Western-Flyer,

    Thanks for your replies.  They were very helpful.

    Do you use “Bearing Puddy” on your wheel bearings?

    in reply to: When to epoxy the inside? #1681

    smithn00
    Participant

    I plan on coating the inside of many panels before I assemble them.

    in reply to: Color Scheme Opinions? #1525

    smithn00
    Participant

    I plan on doing 1 & 2 white and the bottom 2″ black all around.

    in reply to: Water in the Galley #1479

    smithn00
    Participant

    Could you describe the “riser”.  I can’t picture it in my mind.  From where to where.

    Thanks

Viewing 15 posts - 1 through 15 (of 16 total)